Add a device and see the list
What it is for
Section titled “What it is for”It shows all the family’s devices, whether they are connected and whether protection is on. This is where you add a new device.
Where it is
Section titled “Where it is”Devices menu. The screen is titled Family devices.
Add a device
Section titled “Add a device”- Press Add device. Pair Agent opens.
- On the device you want to protect, open the LocalGuard app and scan the code. If you cannot scan it, type the code shown under Or enter the manual code:.
- The code expires after 10 minutes. If it expires, press Add device again.
If you do not have any device yet, the screen shows No linked devices and a link to Installation.
Search and sort
Section titled “Search and sort”- Type in Search by name, IP or identifier to filter the list.
- Use All, Connected or Not connected to see only part of the list.
- Press Refresh to request the latest status of the devices.
Turn protection on or off
Section titled “Turn protection on or off”- Press the device’s Protection switch.
- When you turn it off, the panel asks for confirmation: Turn off protection? Confirm it with Protection disabled.
- To turn it back on, press the switch again. No confirmation is needed.
What happens next
Section titled “What happens next”- Each device shows its connection status: ONLINE, OFFLINE or Unstable (irregular connection), and when it sent its last signal.
- ACTIVE, OFFLINE means protection is on, but the device is not connected right now.
- Pressing a device opens its page, with all its tabs.
What it does not do
Section titled “What it does not do”- With protection off, the device can open blocked content until you turn it back on.
- Turning protection off does not remove the device from your account. For that, delete the device.