See and change protection from the Dashboard
What it is for
Section titled “What it is for”It shows at a glance whether protection is working and lets you turn it on or off on each device without leaving the Dashboard.
Where it is
Section titled “Where it is”- Dashboard → Family protection card: the overall status.
- Dashboard → Home devices card: each device with its protection switch.
- Dashboard → Important changes: a notice when a device has protection turned off.
Read the status
Section titled “Read the status”The Family protection card shows one of these statuses, depending on what you chose in You are viewing the dashboard for:
- ARMED · All good: protection is active and the devices follow your rules.
- DISARMED · Needs attention: protection is turned off. The card is marked in red.
- No data · No connection: the status cannot be confirmed; check that the device has a connection. While it loads, you will see CHECKING….
Review protection takes you to the Protection screen, where the rules are changed.
Turn a device’s protection on or off
Section titled “Turn a device’s protection on or off”- In Home devices, find the device. Each one shows whether it uses the Agent or the Extension.
- Press its protection switch: Click to disable protection or Click to enable protection.
- The change applies immediately, without asking for confirmation.
From Important changes, the Protection is turned off notice has the Enable protection button to turn it back on.
What each device’s colour means
Section titled “What each device’s colour means”Below the title, Device states explains the colours:
- Protected: connected and with protection active.
- Warning: connected, but with protection turned off or stopped.
- Stale: the connection exists, but the signal is not arriving normally.
- No connection: no recent activity has been received, or the extension was uninstalled.
In the Grid view, each device has its own card with a clear message:
- All good: the device is connected and protected.
- Protection paused: it is connected, but protection is not active.
- Worth checking: the signal is not arriving normally.
- No signal: no recent activity has been received.
- Extension uninstalled: the browser extension was removed from that computer. Install it again or delete the device.
- Protection disconnected: protection is stopped on that device (for example, on Android the LocalGuard connection was stopped).
The card also shows STATUS, Last activity, Source (the IP address), the type of Protection (Agent or Extension), the Installed version, the device’s Identifier and the Protection switch.
Other options of the Home devices card
Section titled “Other options of the Home devices card”- List or Grid changes how the devices are shown; it is remembered in this browser.
- The pencil changes the device’s name (see Rename a device).
- Pressing a device opens its page.
What happens next
Section titled “What happens next”- With protection turned off, the device stops filtering: blocked websites open normally.
- The change is recorded in the device’s history and a notice reaches the panel’s bell.
- If the switch shows protection as turned on but the device is not connected, it will apply when it reconnects.
What it does not do
Section titled “What it does not do”- Turning protection off does not delete rules, schedules or activity: when you turn it back on, everything stays the same.
- It does not unlink the device. For that, see Delete a device.
- On the Devices screen, turning protection off does ask for confirmation (see Add a device and see the list).